Water Disposal From The Drip Tray; Replacing The Waterfilter; Error Code Lo - CASO DESIGN HW 1000 Mode D'emploi

4. First press about 3-5 seconds.
5. Press to choose your desired temperature and press
6. Press to operate the device. The desired water will flow out continuously from water
spout.
Press again, when your desired amount of water is dispensed.
The device will stop working at once.
If you want to dispense water again, repeat the steps above.
7.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The appliance has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
14.2.1

Water disposal from the drip tray

1. When the drip tray is full, grasp and stabilize the device by one
hand and use the other hand to lift up the drip tray slightly to
remove it.
2. Empty the drip tray and insert it into the original place. Make
sure it is properly inserted.
14.2.2

Replacing the waterfilter

If the appliance stops to operate with a beeping sound and the display shows the error code
Lo, it means that there is too little water or no water in the water tank. Please fill in enough
water into the water tank immediately.
Please note
and light up.
1. Open the tank cover (A) and take out the filter
box (B) with the old waterfilter (C).
2. Soak the new waterfilter upright in water for 10
min.
3. Rinse the new waterfilter thoroughly under
running water.
4. Remove the old waterfilter and replace it with
the new waterfilter (see fig.). Therefor take out the
filter box, place the new waterfilter and pull it down
from the bottom.
14.2.3

Error code Lo

to set the water volume.
33