Unpacking; Disposal Of The Packaging; Setup Location Requirements; Electrical Connection - CASO DESIGN HW 1000 Mode D'emploi

12.3 Unpacking

To unpack the device, proceed as follows:
Remove the device out of the carton and remove the packaging material.

12.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-related
points of view and can therefore be recycled. Returning the packaging back to the material
loop saves raw materials and reduces the quantities of accumulated waste.
Take any packaging materials that are no longer required to "Green Dot" recycling collection
points for disposal.

12.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
 The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity for the device.
 Place the device only on a waterresistent surface.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not use the device outdoors.
 Do not operate the product near hot gas or hot stove.
 Choose the setup location in such a way that children cannot reach the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs
is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
29