Headphone Connection; Mains Connection - Conrad Electronic McCrypt PA-940/2 Mode D'emploi

Connect the output of your audio
source (mixing desk, equalizer etc)
with the corresponding input terminal
on the amplifier.
Connect the left loudspeaker with the
loudspeaker connections of channel A.
Connect the right loudspeaker with
the loudspeaker connections of chan-
nel B.
24
Connect the left channel with the XLR
connection INPUT (7) CH A and with
the jack plug INPUT (8) CH A, respec-
tively.
Connect the right channel with the XLR
connection INPUT (7) CH B and with
the jack plug INPUT (8) CH B, respec-
tively.
Connect the plus pole of the left loud-
speaker with the red loudspeaker out-
put terminal OUTPUT CH A (11) and
the minus pole of the left loudspeaker
with the black loudspeaker output ter-
minal OUTPUT CH A (11).
When using the speaker connections,
connect the speaker cable of the left
loudspeaker with the loudspeaker con-
nection OUTPUT CH A (10).
Connect the plus pole of the right loud-
speaker with the red loudspeaker out-
put terminal OUTPUT CH B (11) and
the minus pole of the right loudspeaker
with the black loudspeaker output ter-
minal OUTPUT CH B (11).
When using the speaker connections,
connect the speaker cable of the right
loudspeaker with the loudspeaker con-
nection OUTPUT CH B (10).

Headphone connection

Before connecting a headphone, please reduce the volume to
minimum (control left stop) to avoid excessive volumes while
putting on the headphones and thus preventing your hearing from
damages.
Connect a commercially available stereo headphone a 6.3-mm jack bushing to the
headphone jack PHONE (4).
The headphones volume is affected by the volume control (1).

Mains connection

Makes sure that, before you connect the amplifier to the power
supply grid, the operating mode switch (5) is switched off (posi-
tion "OFF").
25