Connection; Signal Inputs - Conrad Electronic Raveland 30 53 02 Notice D'emploi

8. Connection

Signal Inputs

When connecting the signal inputs, make sure that the connection cables are not pinched or
damaged by sharp edges.
The inputs may be connected only to low-level audio outputs of audio devices.
The disco set and the device it is connected to must both be switched off during connection.
For the connection of the RCA inputs, only use suitable shielded RCA cables. Using the wrong
cables can cause interferences.
To avoid distortion or mismatching that may damage the disco set, only audio devices with a
cinch output may be connected to the cinch inputs of the device.
Also observe the values stated in the „Specifications".
• Connect the line-in cinch connection (4) to the pre-amplifier outputs of the upstream audio device (e.g. mixer).
• Connect the CH1 connection to the left pre-amplifier output and the CH2 connection to the right one.
All manuals and user guides at all-guides.com
23