Table des Matières
Publicité
Repairs other than those just described should only be performed
by an authorised electrician.
Technical data
Operating voltage
Power consumption
Fuse:
Input sensitivity:
Input impedance:
Output power:
Frequency response
20 – 20.000 Hz (+/- 1 dB)
Distortion factor (1 kHz/8 Ohm)
S/N ratio
Channel separation
Damping factor (8 Ohm)
30
230V~/50Hz
640 W max.
T 3,15 A
0.9 V
20 kOhm (symmetrical)
2 x 90 W at 8 Ohm
2 x 135 W at 4 Ohm
2 x 250 W max.
< 0,2 %
90 dB
70 dB
200
Intended Use
The Power Amplifier McCrypt PA-940/2 is used to boost any low level audio signals
for domestic or semi-professional equipment and is switched here between the sig-
nal source to be amplified and the loudspeakers.
The amplifier is designed to control loudspeakers with a minimum impedance of
4 Ohm. The device may be controlled with a low level audio source only.
This product is only approved for connection to 230V~/50Hz ac voltage,
respectively and for shockproof sockets only.
Use is only permitted in closed rooms, not in the open-air. Use in humid conditions,
e.g. in bathrooms, should be avoided at all costs.
The above described conditions could damage the product and could cause the risk
of; short-circuiting, fire and electric shock, etc. No part of the product should be
altered or modified and the housing should not be opened!
The safety instructions should be followed at all times!
Individual parts
(see fold-out page)
(1) Volume control LEVEL
(2) Recording level display
(3) LEDs PROTECTION
(4) Headphone jack PHONE
(5) POWER switch
(6) RESET key
(7) XLR connection INPUT
(8) Jack plug INPUT
(9) Fuse holder
(10) Loudspeaker connection OUTPUT
(11) Loudspeaker output terminal OUTPUT
(12) Power cable
19
Publicité
Table des Matières
