Battery Troubleshooting - Ega Master 58875 Manuel D'instructions

If the machine switches off automatically, the machine electronics have activated
automatic protection mode. A warning signal sounds (continuous beeping). The beeping stops
after a maximum of 30 seconds or when the trigger is released. In spite of this protective
function, overloading is still possible with certain applications and can result in damage to the
machine.
Causes and Remedies:
1. Battery almost empty: The electronics protect the battery pack against damage through
total discharge). If one LED is flashing, the battery pack is almost depleted. If necessary,
press the button and check the LEDs to see the charge level. If the battery pack is almost
depleted, it must be recharged.
2. Long continuous overloading of the machine: This will activate the temperature cut-out.
Leave the machine or battery pack to cool. NOTE: If the battery pack feels very warm, the
pack will cool more quickly in an "AIR COOLED" charger. NOTE: The machine will cool
more quickly if you operate it at idling speed.
3. Safety Shutdown: The machine was SWITCHED OFF automatically. If the slew rate of the
current is too high (for example, if the machine suddenly seizes or kickback occurs), the
machine switches off. Switch off the machine at the trigger. Switch it on again and continue
to work as normal. Try to prevent the machine from seizing.
NOTE: The LED lamp switches off automatically after a specific time. To activate the
electronic functions, press the trigger.
24

BATTERY TROUBLESHOOTING