Operating Procedures; Setting The Torque - Ega Master 58875 Manuel D'instructions

1. Ensure the reaction arm is properly attached and secured to the splined section of the torque
tool.
2. Select your desired square drive size and bolt/nut AF size impact socket or hex-drive socket
for use.
3. Secure impact socket onto the tool square drive with a safety pin and secure a safety o-ring
on the socket.
4. See illustration below for details:

SETTING THE TORQUE

1. Momentarily press trigger to activate LCD display (the board will remain energized for
approximately 30 seconds after the trigger is released).
20
PLACING THE TOOL IN SERVICE
Slide Rubber Safety Ring
Over Safety Pin

OPERATING PROCEDURES

Safety Pin
Safety Screw