Cleaning And Maintenance - tomado TPM1501B Mode D'emploi

Regularly clean the coffee machine. This is not only beneficial for the life span of the appliance, it also ensures optimum use of
the appliance and, of course, good tasting coffee.
Cleaning should involve the following:
• Prior to cleaning, always check that the coffee machine is switched off, cooled down and that the plug has been removed
from the socket.
• Regularly clean the outside of the appliance with a slightly damp cloth and then wipe it dry with a dry cloth.
• Regularly clean the water reservoir, leak tray and cup grille of the appliance with hot water and a mild washing-up liquid.
Then rinse thoroughly with hot water and wipe dry.
• Take the filter holder away from the appliance by turning it clockwise. Remove coffee residues and clean the filter holder,
filters and measuring spoon/tamper with water and a mild washing-up liquid. Then rinse thoroughly with hot water and
wipe dry. Attention! Avoid making contact with the blades in the filter for coffee capsules, these are very sharp.
• Remove the attachment from the steam pipe and clean it with hot water and a mild washing-up liquid. Then rinse
thoroughly with hot water and wipe dry. Wipe the end of the steam pipe clean with a slightly damp cloth and then wipe it
dry with a dry cloth.
• Place back all components correctly in the appliance.
Attention: Never use abrasives, alcohol or solvents when cleaning. Never rinse the appliance under the tap or submerge it in
water.
When the coffee machine is not being used for a longer period of time, you must first release the steam in the appliance. This is
done as follows:
1. Check that the steam controller is switched off (turned to 0) and that the steam button (
appliance by pressing the on/off button (
2. Turn the steam tube away from the appliance, use the provided handle for this. Hold a cup under the steam pipe to collect
any released water.
Warning: The steam pipe becomes hot, only grab it by means of the supplied handle.
3. Then slowly turn the steam controller, after which the steam sprays out of the steam pipe. Allow the steam to escape for 3
minutes.
Warning: Never turn the steam controller too quickly, too much steam could be created too quickly otherwise, which in rare
cases could lead to an explosion.
4. Then turn the steam controller closed again (turned to 0) and switch off the appliance. Allow the appliance to cool down and
remove the plug from the socket.
Attention! Avoid contact with steam, this could result in personal injury!
Store the appliance on a dry location at a temperature that is higher than 0 °C.

CLEANING AND MAINTENANCE

STORAGE
) and wait until the steam indicator light lights up continuously.
EN - 19
) is pressed down. Switch on the