Cleaning And Maintenance - tomado TM-1354 Mode D'emploi

NOTE
• If you accidentally put too much water in the
reservoir, it overflows at the rear. Make sure that
the appliance, the plug, the power cord and the
work surface are thoroughly dry before you use the
appliance.
• Turn the pivoting filter to the side.
• Fill the removable permanent filter with the desired
quantity of ground coffee (use approximately 5-6 g
of ground coffee per cup).
• Turn the pivoting filter back into the appliance.
• Place the empty coffee pot on the heating plate.
NOTE
• The appliance has a pause-and-serve function.
Therefore always place the original coffee pot in
the appliance. The lid presses the pause-and-serve
valve upwards so the water can flow.
• Insert the plug into the mains power socket.
• Turn the on/off button to 'I'. The button is
illuminated in red when the coffee maker is switched
on. While the coffee is flowing, you can pour a cup
of coffee. The pause-and-serve valve in the filter
holder will prevent the coffee from flowing. As soon
as you put the pot back in position, the coffee begins
flowing again.
• After use, turn the on/off button to '0'. The red
indicator light in the button goes off. This also
switches off the heating plate.
• After use, remove the plug from the wall socket.
• Turn the pivoting filter to the side.
• Use the handle to remove the filter with the coffee
dregs.
• Empty the filter and rinse it out.
• Put the filter back into the pivoting filter and rotate it
back into the appliance.
• Allow the appliance to cool down for at least 5
minutes before making coffee again. It will then be
safe to refill the water reservoir.

CLEANING AND MAINTENANCE

WARNING:
• Before cleaning the appliance, always switch it off,
unplug it from the electricity supply and allow it to
cool down completely.
Cleaning
• Do not clean the appliance with an aggressive or
abrasive cleaner or with a sharp object, such as a
hard brush or a knife.
• Remove the coffee dregs from the filter.
• Clean the exterior of the appliance with a damp
cloth.
• Dry the outside with a dry cloth.
• Wash the coffee pot, the filter and the pivoting filter
in hot water with a small amount of washing-up
liquid.
• Dry these components thoroughly.
Instruction manual TM-1354
21