Switching Off - tomado TPM1501B Mode D'emploi

1. Slide the removable water reservoir out of the appliance. Fill the water reservoir with cold drinking water. Do not fill it above
the MAX mark. Slide the reservoir back into the appliance and place the water hose in the water reservoir.
2. Place the one- or two-cup filter without coffee in the filter holder, making sure that the ball at the side of the filter falls
precisely into the indentation in the holder. Then place the holder in the appliance from the INSERT position and firmly turn
the handle counter-clockwise to the LOCK position.
3. Check that the steam controller is switched off (turned to 0). Insert the plug in an earthed wall socket and switch on the
appliance by pressing the on/off button (
4. Press the steam button (
creating steam, this temperature is higher than the temperature for making coffee. When the button is not pressed down,
the water will be heated up to the ideal temperature for making coffee.
5. Fill a cup with the drink that you want to heat up, (chocolate) milk. It is important that the cup used is not too small, observe
a minimum diameter of 7.5 mm and take into account that the drink can double in volume when foaming.
6. Remove the attachment from the steam pipe and place the steam pipe in the drink to be heated. If you also want to foam
your drink, leave the attachment on the steam pipe. Make sure that the end of the steam pipe is always in the drink (approx.
2 cm), and not only in the foam for example, to prevent liquid from splashing upwards.
Attention: For the best result, always first hold an empty cup under the steam pipe and open the steam controller for
approx. 15 seconds. In the first shot of steam there is often a lot of water, which can be released in this way.
7. Slowly turn the steam controller, after which the steam sprays out of the steam pipe and your drink is heated up. The
amount of steam can be controlled by turning the button.
Warning: Never turn the steam controller too quickly, too much steam could be created too quickly otherwise, which in rare
cases could lead to an explosion.
8. When your drink has reached the required temperature, turn the steam controller to the closed position again (turned to 0).
After each use, you must properly flush through the steam pipe once to remove residues of (chocolate) milk. For this, hold an
empty cup under the steam pipe. Slowly turn open the steam controller and press down the coffee button
( ). Water is spraying from the steam pipe. After 30 seconds, press the coffee button (
controller again (turned to 0). Throw the water away after flushing. If applicable, remove the attachment from the steam pipe
and clean it as described in section CLEANING AND MAINTENANCE. Do make sure you do not burn yourself!
Attention:
• If you want to make coffee immediately after using the steam pipe, the appliance is still too hot for making coffee. After
using the steam pipe, we recommend switching off the appliance and allowing it to cool down for at least 5 minutes, before
making coffee.
• When the appliance fails while steam is being released, the residual heat ensures that steam continuous to be released for a
certain period of time. The appliance stops producing steam when you turn the steam controller off (turned to 0).
Warning: The steam pipe becomes hot, only grab it by means of the supplied handle.
After use, always switch off the appliance by pressing the on/off button (
switch off the appliance yourself, it will switch off automatically after approx. 30 minutes to save energy. After switching off,
remove the plug from the socket.
After making coffee, do not forget to screw the filter holder out of the appliance and remove the coffee residue. For this, push
the flap on the handle of the holder upwards with your thumb, this makes sure that the filter does not fall out of the holder.
Then remove the filter from the holder and rinse it under flowing water. Empty the water reservoir to prevent scaling. Also
empty the removable leak tray regularly, the floater in the leak tray becomes visible above the cup grille when the leak tray is
full. Allow all parts to cool down before you clean them!
HEATING UP (CHOCOLATE) MILK
), after which the indicator light switches on.
). When the button is pressed down, the water will be heated up to the ideal temperature for

SWITCHING OFF

EN - 18
) once more and close the steam
), the indicator light switches off. If you do not