tomado TPM1501B Mode D'emploi page 17

the handle counter-clockwise to the LOCK position.
• Place a cup in the centre of the cup grille and make sure the steam controller is switched off (turned to 0).
• Insert the plug in the earthed wall socket and press the on/off button once (
• Now press the coffee button (
press the coffee button (
• Check that the steam button (
up to the ideal temperature for making coffee. When the button is pressed down, the water will be heated up to the ideal
temperature for creating steam, this temperature is higher than the temperature for making coffee.
• When the coffee indicator light lights up continuously, the water is at the correct temperature. Press down the coffee button(
) and the water will start to flow.
• Allow the water to flow for 1 minute and then press the coffee button (
your cup is large enough to contain all the water. Then switch off the appliance, remove the plug from the socket and remove
the remaining water from the water reservoir and the cup.
• Allow the appliance to cool down and clean all separate parts as indicated in section CLEANING AND MAINTENANCE.
Attention: The appliance can make more noise when pumping water for the first time, this is normal, as the air in the appliance
is released. After approximately 20 minutes the noise will decrease.
Important: Only fill the appliance with cold water. Hot water has a negative effect on the coffee machine's life span.
1. Slide the removable water reservoir out of the appliance. Fill the water reservoir with cold drinking water. Do not fill it above
the MAX mark. Slide the reservoir back into the appliance and place the water hose in the water reservoir.
2. Take the filter holder from the appliance by turning it clockwise.
3. Fill the one- or two-cup filter with the required amount of coffee by means of the provided measuring spoon. Firmly
compress the coffee using the tamper. Depending on your taste, approximately 1 cup of coffee can be made with 1
measuring spoon. When using coffee capsules for making coffee, you can place the capsules of your taste in the filter
provided for that purpose. Attention! Avoid making contact with the blades in the filter for coffee capsules, these are very
sharp.
4. Place the filter in the filter holder, making sure that the ball at the side of the filter falls precisely into the indentation in the
holder. Then place the holder in the appliance from the INSERT position and firmly turn the handle counter-clockwise to the
LOCK position.
5. Place the required number of coffee cups on the cup grille. Make sure the cups are properly positioned, so that the coffee
flows into the cups.
6. Check that the steam controller is switched off (turned to 0). Insert the plug in an earthed wall socket and switch on the
appliance by pressing the on/off button (
7. Check that the steam button (
up to the ideal temperature for making coffee. When the button is pressed down, the water will be heated up to the ideal
temperature for creating steam, this temperature is higher than the temperature for making coffee.
8. When the coffee indicator light lights up continuously, the water is at the correct temperature. Then press down the coffee
button ( ) and coffee will start to flow. Press the coffee button once more when the required amount of coffee has been
made. If you do not do this, the cup will overflow!
Attention: When making coffee, the coffee indicator light may switch off occasionally, this is normal and happens because
the appliance is continuously heating in order to maintain the correct temperature.
9. Coffee tastes best immediately after it has been made, so do not wait too long before serving.
Tips:
• We recommend slightly warming up an espresso cup prior to use, for instance by first placing it on the hot plate on top of
the appliance. A pre-heated cup will prevent the espresso from cooling down too quickly.
• In order to make a good espresso, we recommend pre-heating the appliance. This is done by first making a cup of espresso
without adding coffee, as a result of which hot water flows through the appliance.
Warning: Do not leave your coffee machine unsupervised when it is working, because of the manual actions you have to
perform.
), the appliance starts to pump water. When water flows out of the filter holder, you must
) once more to stop the flow of water.
) is not pressed down. When the button is not pressed down, the water will be heated
MAKING ESPRESSO/COFFEE
), after which the indicator light switches on.
) is not pressed down. When the button is not pressed down, the water will be heated
EN - 17
), after which the indicator light switches on.
) once more to stop the flow of water. Make sure