Make A Call - Kenwood DPX-M3300BT Mode D'emploi

Bluetooth®
[SETTINGS]
[AUTO ANSWER] [1] to [30]: The unit answers incoming call automatically in the selected
time (in seconds). ; [OFF]: Cancels.
[BATT/SIGNAL]* [AUTO]: Shows the strength of the battery and signal on the supplementary
display (page 28) when the unit detects a Bluetooth device and the
Bluetooth device is connected. ; [OFF]: Cancels.
* Functionality depends on the type of the phone used.

Make a call

You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
other phone.
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press
[CALL HISTORY] (Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "INCOMING," "OUTGOING" or "MISSED" is shown on the lower part of
the display to indicate the previous call status.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history or call number.
2 Press the volume knob to call.
Default: [XX]
[PHONE BOOK]
again to switch to the
[NUMBER DIAL]
[VOICE]
.
[LOW]/[MID]/[FULL]: Shows the strength of the battery.*
[NO SIGNAL]/[LOW]/[MID]/[MAX]: Shows the strength of the current received signal.*
* Functionality depends on the type of the phone used.
(Applicable only if the phone supports PBAP.)
1 Turn the volume knob quickly to enter alphabet search mode (if the
phonebook contains many contacts).
The first menu (ABCDEFGHIJK) appears.
• To go to the other menu (LMNOPQRSTUV or WXYZ1 ), press 1
2 .
• To select the desired first letter, turn the volume knob or press
S / T, then press the knob.
Select "1" to search with numbers and select " " to search with
symbols.
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the knob to
call.
• For using phonebook with this unit, make sure to allow access to or
transfer from your smartphone. Depending on the connected phone, the
process may be different.
• Contacts are categorized as: HOME, OFFICE, MOBILE, OTHER, GENERAL
• This unit can display only non-accent letters. (Accent letters such as "Ú"
are shown as "U".)
1 Turn the volume knob to select a number (0 to 9) or character ( , #, +).
2 Press S / T to move the entry position.
Repeat step 1 and step 2 until you finish entering the phone number.
3 Press the volume knob to call.
Speak the name of the contact you want to call or the voice command to
control the phone functions. (See also "Make a call using voice recognition"
on page 16.)
/
15
ENGLISH