Kenwood DPX-M3300BT Mode D'emploi page 14

Getting Started
[F/W UPDATE]
[UPDATE SYSTEM]
[F/W UP xxxx] [YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<https://www.kenwood.com/cs/ce/>.
• Once you have upgraded the firmware, you are unable to downgrade
the firmware.
[FACTORY RESET] [YES]: Resets the settings to default (except the stored station). ;
[NO]: Cancels.
[ENGLISH]
[РУССКИЙ]
Select the display language for [FUNCTION] menu and music information
[ESPANOL]
if applicable.
By default, [ENGLISH] is selected.
[FRANCAIS]
[DEUTSCH]
6
ENGLISH
Change the crossover type
Press B SRC repeatedly to enter STANDBY.
1
2 Press and hold number buttons 4 and 5 to enter crossover select.
The current crossover type appears.
3
Turn the volume knob to select "2WAY" or "3WAY", then press the
knob.
4
Turn the volume knob to select "YES" or "NO", then press the knob.
The selected crossover type appears.
• To cancel, press and hold
• To adjust the selected crossover settings, see page 20.
Once you have changed the crossover type, the next time when you turn on
the power, the display shows:
"2-WAY X ' OVER" or "3-WAY X ' OVER"
"TO CONFIRM"
Press the volume knob to acknowledge in order to proceed to the next
desired operation.
CAUTION
Select a crossover type according to how the speakers are connected.
(Page 26, 27)
If you select a wrong type:
• The speakers may damage.
• The output sound level may be extremely high or low.
.
"PRESS" "VOLUME KNOB"