Cleaning And Maintenance; Replacing The Sewing Light - VALBERG 972697-VB-MAC Consignes D'utilisation

C

Cleaning and maintenance

Cleaning and maintenance
CAUTION!
• Always turn off and unplug the unit from the mains
socket before cleaning it.
• To avoid all electricity-related risks, never immerse the
unit, cable, power plug or foot control in water or any
other liquid. Never rinse them under a tap.
Important: Do not use solvents, chemical or abrasive
cleaning products, wire brushes, sharp objects or
scouring pads to clean the unit.
• Clean the machine with a soft, dry cloth.
• Open the bobbin cover, take out the bobbin and use a small
brush to clean the bobbin case. Close the cover again.
• Do not expose the machine to high temperatures.
• Do not drop the machine.
• Change the accessories as described in this user manual.
• Always ensure that the accessories have been correctly installed
before plugging in the machine.

Replacing the sewing light

DANGER!
Before replacing the sewing light, unplug the machine
from the mains socket to avoid an electric shock.
1. Unplug the machine from the mains socket.
2. Loosen the screw on the back of the front cover as shown.
3. Close the front cover.
4. Observe the LED bulb's + and - connections, then remove it.
5. Replace the LED bulb with a bulb with the same rated power (≤ 0.6 W and LED voltages
≤ 3.2 V, LED Φ 5 mm).
60 EN