Publicité
Les langues disponibles
Les langues disponibles
B
Product usage
Threading the machine
The bobbin is located at the bottom of your machine and provides the lower thread for your
stitches.
This sewing machine uses metal bobbins. The bobbin case is magnetised. Use the metal
bobbin to obtain the correct tension for the bobbin thread. Always use 15K-type metal bobbins.
Important: Only use metal bobbins in this sewing machine. The bobbin thread is
magnetically tautened. Therefore, a metal bobbin is required. Should transparent
or plastic bobbins be used - even if they seem to fit into the machine - the machine
will not be able to operate properly and unsatisfactory stitches will be obtained.
Using metal bobbins will result in correct stitches.
Winding the bobbin
1.
Make sure the on/off switch is set to "OFF".
2.
Insert the spool base, spool of thread and spool cap onto the spool pin.
3.
The thread should face the back of the spool. Make sure that when the thread is pulled
from the left, the spool of thread turns anticlockwise as shown.
45
EN
Publicité
