VALBERG 972697-VB-MAC Consignes D'utilisation page 48

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

B
Product usage
4.
Pass the thread under the slot to the right of the thread guide, then through it; next, wrap
the thread around the tension guide and pull the thread to the right as shown.
5.
Pass the thread through an upper hole in the bobbin from the inside to the outside. Then
place the bobbin on the bobbin winder and push it in until it clicks into place.
6.
Firmly push the bobbin winder and bobbin to the right, against the bobbin winder stopper.
7.
Hold the end of the thread and step on the foot control to wind the bobbin a few turns.
Remove your foot from the pedal to stop winding. Release the end of the thread and cut
it near the top of the bobbin.
46
EN

Publicité

Table des Matières
loading

Table des Matières