4/ Caring For And Cleaning Your Appliance; Maintenance - Fagor 60CFP36IX Guide D'utilisation

4/ CARING FOR AND CLEANING YOUR APPLIANCE

MAINTENANCE

Proper maintenance of the Range Hood will
assure proper performance of the unit.
Filters
The filters must be cleaned approximately once
every 30 hours of operation.
Use a warm detergent solution. Grease filters are
dishwasher safe.
Remove filter by pushing filter towards the back
of hood and rotating filter downward
Duct free (Carbon) Filters
The duct free filters should be changed every 6 months. Rotate the filters to remove and
replace.
Cleaning the Hood
Stainless steel is one of the easiest materials
to keep clean. Occasional care will help preserve its fine appearance.
Cleaning tips:
Hot water with soap or detergent is all that is usually needed.

Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to avoid

water marks.
For discolorations or deposits that persist, use a non-scratching household cleanser or

stainless steel polishing powder with a little water and a soft cloth.
For stubborn cases, use a plastic scouring pad or soft bristle brush together with

cleaner and water. Rub lightly in direction of polishing lines or "grain" of the stainless
finish. Avoid using too much pressure which may mar the surface.
DO NOT allow deposits to remain for long periods of time.

DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the

surface causing rust.
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to

remain in contact with stainless steel for extended periods. Many of these compounds
contain chemicals which may be harmful. Rinse with water after exposure and wipe
dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only
HALOGEN BULBS
To change bulbs:
1 Use a screwdriver to pull out the lampshade and get off the glass. CAUTION: BULB
MAY BE HOT, PLEASE ROTATE WHEN
THE BULB IS COOL!
2 Replace with a Type JC, 12Volt, 20Watt
Max, G-4 Base bulb. Do not touch
replacement bulb with bare hands!
3 Fix the glass and lampshade back the light
after replacing the bulb.
.
11
EN
.