Caring For And Cleaning Your Appliance; Changing And Cleaning The Anti-Grease Filters; Changing The Light Bulb; Install The T-Sharp Outelt - Fagor 9 CFV 92 IX Guide D'utilisation

EN

4 / CARING FOR AND CLEANING YOUR APPLIANCE

• CHANGING AND CLEANING THE ANTI-GREASE FILTERS

— Removing the fi lters as the instruction in Pic. 12
— You can clean the fi lter as below measure:
1. Soak them for about 3 minute in hot water
(40-50 degrees) with a grease-loosening
detergent then brush it gently with a soft brush.
Please do not apply too much pressure, avoid
damaging it.
2. It can be put into a dishwasher with
detergent, set the temperature at around 60
degrees.
— Please do not use abrasive detergent for it will
damage the hood;
— Make sure that the hood is shut off before
cleaning;
— Installing the carbon fi lter:
1. Remove the Al fi lter, see Pic.12
2. Insert the carbon fi lter in the rectangular
hole, fi tting it over the motor.
3. After inserting the front edge of the carbon
fi lter into the slot on the cooker hood. Lower
the back edge of the carbon fi lter, until it
clicks into place at the rear of the rectangular
hole. Raise the two fi xing bars, until they are
horizontal over the carbon fi lter. See Pic 13
4. Place the Al. fi lter back to position.
5. Apply reverse procedure to uninstall the
carbon fi lter.
Warning
the charcoal cannot be washed or re-
cycled. It should be changed at least every
four months.

• CHANGING THE LIGHT BULB

Take the bracket and glass off and then take
the broken light bulb off, See Pic 14.
Fix the new light bulb,glass and bracket on.
Attention
Before changing the lights, ensure
that the appliance is not live.

• INSTALL THE T-SHARP OUTELT

— Fix the outlet outlet on the T-sharp, see
Pic 15.
— Fix the T-sharp outlet on the inside
chimney, see Pic 16.
Pic 15
20
Pic 12
Pic 13
Pic 14
Pic 16