2/ INSTALLING YOUR APPLIANCE
PREPARING THE HOOD
Note: On stainless steel hoods, carefully
remove the plastic protective film from all
exterior surfaces of the hood and decorative
flues, prior to final installation.
1
Remove the hood from the carton.
2
Install the vent into the duct connector of the
hood with 4 pcs mounting screws (4*8mm).
INSTALLING THE HOOD
Note: at least two people will be required to mount the
hood.
1
Raise the hood into its mounting position.
2
Fix the hood onto the angle irons with 16 pcs of mounting
screws (4*14mm). See picture as shown.
3
Pull the duct as the direction showed on the picture, and
make it attach onto the vent.
4
Loosen the slide, and pull the outside chimney as shown.
9
EN