Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Remove bumper: Remove the (4) flange nuts
6. Install hitch: Raise the hitch into position as shown (see Figure 1), over the existing stud/bolt on vehicle.
(m18 wrench and/or deep well socket) holding
Reinstall bumper over hitch and secure with existing flange nuts removed in step 5.
the bumper in place, flange nuts to be reused for
hitch installation.
7. Tighten all M12 CL10 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
8. Trim or push heat shield: Trim around the hitch as needed or simply push
the heat shield forward away from hitch.
Proper torque is needed to keep the hitch secure to the vehicle when towing.
© 2022 Horizon Global™ Corp. - Printed in Mexico
Sheet 5 of 18
76628NP
10-28-22
Rev. A
Publicité
Table des Matières
