Horizon Global 76628 Instructions D'installation page 4

1. Remove taillights: Open trunk and remove
access panel to the taillights, remove 3
flange nuts (m8 socket) each side. Note:
Recommend removing tie down loop on
passenger side for additional clearance
(T40 torx bit). Remove taillight and
disconnect wiring.
3. Fascia removal: Gently pull up from the rear wheel well trim panel each side, unclipping the tabs inside.
Work up to taillights and continue to gently remove along plastic taillight support. Using a small screwdriver
or trim tool push down on cleats between the fascia and taillights as needed. Continue to remove along
inside bottom to the trunk, lifting fascia up from bottom as needed. Carefully pulling the fascia away from
the vehicle. If present, disconnect any wiring harness or sensor from fascia. If present, remove sensors from
fascia by opening the small square holders, both sides. See Figure 6. Move the fascia cover aside.
© 2022 Horizon Global™ Corp. - Printed in Mexico
2. Fascia removal: From under the vehicle remove 2 bolts (m10 socket) see Figure 2 & 3. Remove 2 bolts (each
side)(m10 socket) under vehicle near wheel well. See Figure 2. Remove 3 (each side) plastic rivet in wheel well.
Use small screwdriver or plastic trim tool or pliers to remove the center pin, remove remaining body of rivet.
Gently pull wheel well trim from fascia enough to clear where rear fascia and side fascia meet. Remove 1 (each
side) rivet under the wheel well cover using the same technique see Figure 4. Remove 1 (each side) (m8) screws
located behind the wheel well covering. See Figure 5.
6 FLANGE NUTS FOR
TAIL LIGHTS
8 PLASTIC RIVETS
6 SCREWS UNDER FASCIA
2 SCREWS UNDER WHEEL
WELL TRIM
4. Lower exhaust: Un-bolt the exhaust from the
bumper attachment using a 12-point 3/8"
socket. Both sides.
Sheet 4 of 18 76628NP 10-28-22 Rev. A