Date/Time And Contrast Setting - Lenze EPM-H502 Instructions De Mise En Service

5 Commissioning

Date/time and contrast setting

5.4 Date/time and contrast setting
You want to ...
A
set the date/time and contrast on the
display.
1. Briefly touch the display in one of the
corners 0, 1, 2 or 3.
– Note: This corner must not contain
a selectable field.
2. Immediately touch the diagonally
opposite corner for a moment.
3. Select the menu for time/date and
contrast.
B
set date/time.
1. Touch the "SET CLOCK" field to select
the menu.
2. Select the desired field.
3. Change the value.
4. If necessary, repeat steps 2. and 3. to
change additional values.
5. Confirm the input.
– The menu for time/date and
contrast is displayed.
C
set the contrast of the display.
1. Touch the "SET CONTRAST" field to
select the menu.
2. Set the contrast.
3. Confirm the input.
– The menu for time/date and
contrast is displayed.
D exit the date/time and contrast menu
and close the status display.
74
Touch the fields ...
PROG
More contrast
Less contrast
ESC
l
Example
0
3
Port : NET
Driver : CAN Lenze M
Ver : X.XX
Addr : NO ADDRESS
Error : RESET
SET CONTRAST : 04
or
12.50.10 13/09/00
or
SET CONTRAST : 04
CONTRAST : 04
2x
1
2
PROG
TRANS
PAGE
ESC
SET CLOCK:
Wed,13/09/00
12:50:10
ESC
ESC
SET CLOCK:
Wed,13/09/00
12:50:10
ESC
ESC
EDBPM−H502 DE/EN/FR 5.1