Waste Disposal - Master Trimmers MT Professional 50 Manuel D'utilisation Et De Maintenance

Finally, sharpen the cutting area of the blades. If you need more
5
information on how to sharpen the blades, contact Master
Products.
Replace the grid back on top and fasten it with the four fasteners.
7
Disassembly and dismantling
+
Before proceeding with disassembly, all possible energy and/or electricity supplies must be cut off.
+
Waste must be disposed of according to the corresponding national regulations.
+
For disassembly and dismantling operations, use the following personal protective equipment: gloves and
protective glasses.
+
Covers, flexible ducts and components made of plastic material (or any non-metallic material) must be
disassembled and disposed of separately.
+ Hydraulic and electrical components (such as valves, solenoid valves, etc.) must be disassembled for reuse, if
they are in good condition, or, if possible, checked and recycled.
+
Take the components to an authorized recycling centre so that they are recycled and/or disposed of in an
environmentally safe way. Recycle unwanted materials instead of disposing of them.

Waste disposal

Waste must be disposed of according to the corresponding national regulations.
36
To reassemble the MT Professional 50 or 75, position the blades
6
as shown in the following image. Using the Allen key Nº 4, fix
them to the shaft with the screws that were previously removed.
Replace the container and fix it with the help of the two retaining
8
knobs (F).
www.masterproducts.es