Master Trimmers MT Professional 50 Manuel D'utilisation Et De Maintenance page 33

Loosen, without removing, the two side bolts shown in the
6
following image using fixed spanner Nº 13, and repeat the same
process with the two bolts on the opposite side.
Replace the protection grid and fix it with the help of the four latches. Screw in or unscrew the threaded studs to raise or lower the blades as
8
required. Measure the distance between the two ends of the blades and the grid with a caliper or other measuring instrument as shown in
the following image.
If the distance is not the same, it will be necessary to adjust the height, screwing or unscrewing the threaded studs, as
appropriate.
Once the blades are level, remove the grid and secure the two
9
side bolts on both sides with the help of the fixed spanner Nº 13,
as shown in the following image.
Replace the protection grid and fix it with the help of the four
11
latches.
The red coloured support in the following image has been
7
released and is free to move. Screwing or unscrewing the four
threaded studs on it and enabled for this purpose allow the blades
to be levelled, but before doing that, the grid must be placed as
described in the next step.
=
Next, tighten the four nuts shown in the following image, using the
10
Allen key Nº 3 and fixed spanner Nº 10.
Replace the container and secure it with the help of the two
1 2
retaining knobs (F).
www.masterproducts.es
=
33