Renkforce DJM700U USB-CLUB-MIXER Mode D'emploi page 34

PHONO/LINE CH-1 to CH-3 (35)
The mixer is equipped with three RCA stereo inputs for the connection of your record player. These inputs
are variable inputs. They can be set using the respective PHONO/LINE (36) switches above the sockets.
Depending on the switch position these inputs can be connected to a record player or a LINE device.
Switch set to LINE (switch pressed)
Switch set to PHONO (switch not pressed) A record player with a magnetic system (this system is used
Only put the switch in the PHONO position if a record player is connected. Select LINE for any
other devices.
The input signal is distorted if the switch position is incorrect. There is the risk of damage to the
connected amplifier or the loudspeakers. Only press the switch when the mixer is not switched
on. If no device is connected to the sockets, set the switch to LINE.
EFFECTS RETURN TO MAIN socket (48)
The EFFECTS RETURN TO MAIN RCA socket is mainly used as input for a modified effect signal. Connect
the output of the effect unit here.
MIC connection (1)
You can connect your microphone to this input. This connection is suitable for a dynamic microphone or a
condenser microphone with its own power supply. The microphone input is equipped with a special socket.
You can connect a 6.3 mm jack plug (unsymmetrical) or an XLR plug (symmetrical).
The input is not suitable for a LINE level device or a record player.
USB connection (52) CH4
You can connect the USB interface of your computer to this input. Your computer can be used as a play-
back device as well.
The interface does not support storage media such as harddisks or memory sticks that are not
equipped with a playback function (player).
MIC AUX RETURN connection (39)
The MIC AUX RETURN sockets are mainly used as the input for a modified stereo effect signal. Connect the
output of the effect unit here. When a mono signal is supplied, use the MIC AUX RETURN L socket (MONO).
34
A device with LINE level, e.g. CD player, MP3 player or radio,
can be connected to the respective input.
with almost all DJ record players) can be connected to the
respective input.