Raider RD-GCS20 Manuel D'instructions page 21

Keep maximum speed for the whole time.
Allow the chain to cut wood. Press down the saw lightly.
Stop pressing the saw at the end of the cut to avoid losing control over the tool.
When the cutting has been finished release the throttle lever (11) and allow the engine to run idle.
Switch off the engine before putting the chain saw away.
Keeping high speed of the engine when not cutting wood causes unnecessary losses and wear of parts.
4.11. Protection against recoil.
Recoil is movement of the guide bar of the chain saw up and/or back, which happens when the part of the chain on the
guide bar tip encounters an obstacle.
Ensure the processed material is firmly fixed.
Use clamps to fix the material.
Hold the chain saw with both hands when starting up and during operation.
During recoil the chain saw cannot be controlled and the chain is loosened.
Incorrectly sharpened chain increases risk of recoil.
Do not cut above level of your shoulders.
Avoid cutting with guide bar tip, it may cause sudden recoil - to the back and up. Always use complete safety equipment
and appropriate working clothes when operating the chain saw.
Disassembly of protections, inappropriate operation, maintenance, improper guide bar or chain replacement may
contribute to increase of risk of body injury in case of recoil. Never modify the saw in any way. By using modified chain saw,
the user looses all warranty rights. Warranty voids also when the chain saw is used in accordingly to information contained
in this manual.
4.12. Cutting pieces of wood.
When cutting wood follow guidelines for safety of work and do as follows:
Ensure the wood piece cannot be moved.
Use clamps to fix short pieces of material before cutting.
Cut wood or wood-like materials only.
Before cutting ensure the chain saw will not come into contact with stones or nails, as it could cause pulling the saw out
and damage to the chain.
Avoid situations when working saw might touch wired fence or ground.
When cutting branches support the saw as much as possible and do not cut with the tip of the guide bar.
Watch out for obstacles such as protruding stumps, roots, hollows and holes in the ground, as they may be cause of an
accident.
4.13. Felling a tree.
Felling trees require great experience. Do not perform activities for which you are not qualified!
Define the tree fall line. Consider wind, lean of the tree, location of heavy branches, complexity of work after tree fall and
other factors.
When tidying area around the tree remember to ensure proper ground grip and escape path to use when the tree falls.
Predict and tidy up two escape paths at 45° angle, counting from the line opposite to expected line of the tree fall. There
must be no obstacles on these paths.
А. Direction of tree felling.
21