Kozy Heat Fireplaces KOMFORT ZONE KIT Mode D'emploi page 12

3.2.2 Combustible Wall Finish
• Figure 3.6 shows installation of combustible wall finish up to 1"
thick. This combustible material goes on any required non-
combustible materials as shown in Figure 3.1 on page 10.
• This 1" (25mm) combustible material is able to go down to the
fireplace finishing edge.
• See Figure 3.4 on page 11 for up to 1" (25mm) thick
combustible material installation around the discharge trim of
the KZK air discharge opening.
NON COMBUSTIBLE ZONE
COMBUSTIBLE WALL FINISH
UP TO 1" (25mm) THICK MAY BE
INSTALLED OVER CEMENT BOARD
Non-combustible
material only
TOP
FINISHING
EDGE
BOTTOM
FINISHING
EDGE
Figure 3.6, KZK-072 Combustible Wall Finish
12
FIREPLACE ENCLOSURE FLOOR
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces Komfort Zone Kit #KZK-072 R.4