VALBERG CNF 268 F WD B625C2 Consignes D'utilisation page 14

B
Connecting to the mains.
Your appliance is designed to operate at a single-phase voltage of 230 volts. It must be connected
to a plug with an earth contact and protected by a fuse. The electrical system must be compliant
with standard NF C 15-100.
DOOR
You can change the direction in which you appliance door opens by moving the hinges. Make
sure that the door is correctly aligned with the unit and that the seal is properly stuck down
when replacing the door.
We should remind you that the appliance must be unplugged when changing the direction
of the door.
You should prepare a foam support or similar material before positioning the refrigerator on
its back to access the base in order to prevent the cooling circuit at the back of the refrigerator
from being damaged.
Remove the hinge cover
Loosen the screws used to attach the upper right door hinge.
Using the appliance
Upper left hinge
Self-tapping
screws with
special base
7 EN