Changing The Radio System To Commeo - Selve commeo 297774 Mode D'emploi

EN
iveo initial operation/Setting
If the motors/receivers are still moving together, repeat the proce d ure
for the motors/receivers affected.
If you did not programm a transmitter through the STOP button and
no other transmitter is programmed, you may programm this trans-
mitter again by pressing the UP and DOWN buttons at the same time
and then pressing the PROG button.

5.9. Changing the radio system to commeo

To change the radio system of a motor/receiver with iveo transmitters,
first set the motor/receiver to service mode and then select the motor/
receiver using a commeo transmitter by pressing the SELECT button
for 3 seconds. When the motor/receiver has been selected, all iveo
transmitters have been reprogrammed.
Fuse
➧
3 s 3 s 3 s 3 s
48