Reprogramming If A Transmitter Is Damaged Or Lost; Resetting To The Delivery Status - Selve commeo 297774 Mode D'emploi

EN
iveo initial operation/Setting

5.6. Reprogramming if a transmitter is damaged or lost

Only use if a programmed transmitter is no longer available (damaged
or lost)!
In order to program a new transmitter, the receiver has to be put into
reprogramming mode by disconnecting it from the mains supply.
Subsequently press the PROG button of the new transmitter for
3 sec. All the old transmitters have been deprogrammed.
Fuse
3 s 3 s 3 s

5.7. Resetting to the delivery status

To return the receiver to the state at delivery, the receiver must be
brought into service mode by disconnecting it. T hen press the PROG
button of an assigned transmitter for 9 seconds.
The receiver will then have no transmitters or limit positions saved.
Fuse
3 s 3 s 3 s
New transmitter
➧
3 s
Assigned transmitter
➧
3 s
46