iveo initial operation/Setting
5.4. Functions in service mode
In order to carry out the following settings, the receiver has to be put
into service mode by disconnecting it from the mains supply in a
special way.
Consider the following:
• T ransmitter programmation has to be finished before service mode
can be executed.
• Put only the receiver which is to be set into service mode.
• The receiver remains in service mode for 4 minutes.
• I n order to leave the service mode just drive the motor/receiver up
or down.
Fuse
3 s
3 s
3 s
The receiver confirms the service mode by a brief up and down
moving.
5.5. Resetting the runtime
Setup-mode can only be finished by programming both end posi-
tions.
The transmitter assignment is not affected by this. When setting the
end positions, the motor/receiver is in the normal operating state
again.
Put the motor/receiver into service mode by disconnecting it. Press
the STOP button of an assigned transmitter for 6 seconds to return
the motor/receiver to setting mode (wait until the transmitter indicator
flashes twice). Then set the runtime as described in the grey section
for item 5.
Fuse
3 s
3 s
3 s
Assigned transmitter
STOP
6 s
➧
45
EN
EN