Programming Transmitters/Channels; Programming Further Transmitters/Channels; Deleting Of Transmitters/Channels; Intermediate Positions - Selve commeo 297774 Mode D'emploi

EN
iveo initial operation/Setting

5.1. Programming transmitters/channels

5.1.1. Programming further transmitters/channels

Press the PROG button of a programmed transmitter/channel for
3 seconds (wait for confirmation run from the motor/receiver). The
motor/receiver is now in programme mode for 1 minute. Press (1 sec.)
the PROG button of the new transmitter/channel. The new trans-
mitter/channel has now been programmed.
Programmed
transmitter/channel
➧
3 s

5.1.2. Deleting of transmitters/channels

Press the PROG button of a programmed transmitter/channel for
3 seconds (wait for confirmation run from the motor/receiver). The
motor/receiver is now in programme mode for 1 minute. Press (1 sec.)
the PROG button of the transmitter/channel you wish to delete. The
transmitter/channel has now been deleted.
Programmed
transmitter/channel
➧
3 s

5.3. Intermediate positions

For setting and calling the intermediate positions, see the transmitter
instructions.
New
transmitter/channel
1 s
Transmitter/channel
to be deleted
1 s
44