Selve Commeo/Iveo Radio - Selve commeo 297774 Mode D'emploi

EN
General

2.2. SELVE commeo/iveo radio

All SELVE commeo Receive Connect receive radio signals on
868.1 MHz (commeo radio) and 868.3 MHz (iveo radio). T he two radio
systems can not be operated at the same time.
commeo is a bidirectional radio system that saves data in the receiver
as well as the transmitter. iveo is an unidirectional radio system which
is compatible with the intronic radio system.
The receiver is compatible with both radio systems after it has been
disconnected from the mains supply as long as the teaching process
for a commeo/iveo transmitter has not already been completed. If you
wish to change the radio system retrospectively, the programming for
all transmitters of the other radio system must be re-programed. The
receiver must then be disconnected from the mains supply.
All SELVE commeo/iveo transmitters can be programmed into these
receivers. Up to 16 transmitters can be programmed into one motor.
Please adhere to the transmitter operating instructions.
The commeo receiver can be set for different applications in the
CONFIGURATION mode. The commeo Receive Connect is already
set for 'venetian blind'. To operate the commeo receiver, it is neces-
sary to set the runtime of the blind. The runtime is not set from the
factory. An error message appears in the operating mode. During iveo
operation a change of the receiver application is not possible.
Note:
Ensure that the controls are not installed and operated in the vicinity
of metal surfaces or magnetic fields. Metal surfaces or panes of glass
with a metallisation within the transmission path can reduce the
range considerably.
Radio sets transmitting at the same frequency could interfere with
reception.
It should be noted that the range of the radio signal is restricted by
legislation and constructional measures.
32