Starting The Engine - Cold Start - Garten Meister GM BFS 2T-52 Mode D'emploi

Starting the Engine – Cold Start
1. Place the Start/Stop switch (15)
to the position "I" (Start).
2. Move the choke downwards (to
the position "ON").
3. Grasp the control handle with
the right hand. This way the
throttle lock
pressed. Push the throttle (12)
and the half-throttle lock button
(14) simultaneously.
4. Press the primer several times, until the
transparent bubble fills with fuel. The
primer is situated beneath the air filter
cover (7).
5. Hold the half-throttle lock button (14)
pressed and release the throttle (12) and
the throttle lock (13). The half-throttle lock
button (14) will automatically remain in the
depressed position.
6. Release the control handle.
7. Hold the machine with the left hand and pull the starter handle (8)
with the right hand quickly and vigorously 4 to 5 times up to the
cable end, until the engine starts.
Please note that the engine will start at half acceleration and with
rotating trim head.
8. Let the engine run at idle speed for some seconds to warm up.
9. Press the throttle (12) shortly and the half-throttle lock button (14)
will switch off automatically. Move the choke up the half back to the
position OFF. Press the throttle again. Afterwards move the choke
back to the position OFF.
The engine returns to idle speed again. The spindle with the
mounted trim head stops after some seconds.
Operation
(13) will be
Choke
16
Primer