Using The Carrying Harness; Blocking The Drive Shaft - Garten Meister GM BFS 2T-52 Mode D'emploi

Using the carrying Harness

Always use the machine with a suitable carrying strap
or carrying harness.
1. Hook the machine into the locking hook and
balance it while the engine is turned off.
2. Put on the carrying harness and close it with the
plastic buckle. Adjust it to your body size.
3. Hook the machine into the locking hook on the on
the heat shild oft he harness.

Always turn off the machine before detaching it
from the carrying strap.
Attention! There is a danger of accidents!

Hang the machine by the locking hook. The
cutting tool my barely touch the ground. If needed
loosen the bracket (5) with the included hex key
and slide the bracket back or forward.

Blocking the drive Shaft

Counter the counterpiece with the hex key.
In the tool socket and in the counterpiece
there are suitable holes.
Insert the hex key into the hole, and turn
the shaft until the hex key slips into the
hole in the counterpiece, and thus blocks the counterpiece.
Assembly
11