R&G CP0275 Guide Rapide page 3

Left-hand side (as you sit on bike)

Remove engine bolt in position arrowed in picture ONE (ensure frame to engine spacer remains in
place).

Using the spanner flats on the longest spindle bar (SB061) engage the spindle bar by
approximately 65mm.

Place the 16mm spacer (S0203) over spindle bar.

Place either crash protector over spindle bar so the flat face is against spacer just fitted.

Place shake proof washer over spindle bar and into crash protector counter-bore.

Place plain washer over spindle bar and into crash protector counter-bore up against shake proof
washer.

Engage and tighten the M12 Nyloc nut ensure the spindle bar threads engage in plastic locking
portion of the nut, PLEASE NOTE CRASH PROTECTOR MUST BE POSITIONED AS
SHOWN IN PICTURE THREE WITH BIGGER END TOWARD FRONT OF BIKE. Do
not over tighten as damage can occur to the bike. Do not exceed 40nm of torque.

Insert protector cap into crash protector so logo is as shown in picture THREE.
Right-hand side (as you sit on bike)

Remove engine bolt in position arrowed in picture TWO (ensure frame too engine spacer remains
in place).

Using the spanner flats on the shorter remaining spindle bar (SB060) engage the spindle bar by
approximately 65mm.

Place the remaining crash protector over spindle bar so the flat face is against the frame bracket.

Place shake proof washer over spindle bar and into crash protector counter-bore.

Place plain washer over spindle bar and into crash protector counter-bore up against shake proof
washer.

Engage and tighten the M12 Nyloc nut ensure the spindle bar threads engage in plastic locking
portion of the nut, PLEASE NOTE CRASH PROTECTOR MUST BE POSITIONED AS
SHOWN IN PICTURE THREE WITH BIGGER END TOWARD FRONT OF BIKE. Do
not over tighten as damage can occur to the bike. Do not exceed 40nm of torque.

Insert protector cap into crash protector so logo is as shown in picture THREE.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for
its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify
any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be
liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or
the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
CONSUMER NOTICE
R&G Racing
www.rg-racing.com Email: info@rg-racing.com