Switching On; Signals: Leds And Vibrations - A-Net Mode - ARAG explorer Installation, Utilisation Et Entretien

SWITCHING ON

GB
• Starting the device
First, the LED (Fig. 11) indicates that the device is operating.
L2
1 repeated flash of
L2
2 repeated flashes of
• Operation test
Once the device has started, the joystick runs an operation test in the following manner:
simultaneous illumination of all LEDs, backlit keyboard and 1 long vibration.
The device enters the "Main" page functions and triggers the following signals.
Refer to the "Signals: LEDs and vibrations" paragraph for your mode.
SIGNALS: LEDS AND VIBRATIONS - A - NET MODE
Fig. 11
LED no.
- steady on: page 1 ONLINE
- consistent flashing: page 1 bis ONLINE
L1
- off: Main page ONLINE
- off: page 2 ONLINE
- off: no error
- 1 periodical flash: CANBUS communication error
- 2 periodical flashes: the monitor has not correctly configured the joystick
- 3 periodical flashes: hardware error [03]
L2 - 4 periodical flashes: supply voltage too high
- 5 periodical flashes: supply voltage too low
- 6 periodical flashes: hardware error [06]
- 7 periodical flashes: hardware error [07]
- fast regular flashing: signal managed by the connected monitor
- steady on: page 2 ONLINE
L3 - off: Main page ONLINE
- off: page 1 / 1 bis ONLINE
- steady on: associated function ON
L4
- off: associated function OFF
LEGEND:
- consistent flashing = constant flashing
- periodical flashing = set of several flashes separated by pauses
LED: start in A-NET mode.
LED: start in ISOBUS mode.
L2
LED STATUS
L4: CENTRAL BUTTON STATUS
• Press active keys
The device vibrates (1 short vibration) when any button is pressed.
VIBRATION
L1: PAGES 1 / 1 bis
1 vibration + 1 pause
1 vibration + 1 pause
none
2 vibrations + 1 pause
L2: ALARM LEDs
none
none
none
none
none
none
none
none
1 long vibration + 1 pause
L3: PAGE 2
2 vibrations + 1 pause
none
1 vibration + 1 pause
none
none
13