Wiring Connections; General Precautions For A Correct Harness Position; Harness Connection - ARAG explorer Installation, Utilisation Et Entretien

WIRING CONNECTIONS

GB
• Use only the cables provided with the ARAG devices.
• Take care not to break, pull, tear or cut the cables.
• Use of unsuitable cables not provided by ARAG automatically voids the warranty.
• ARAG is not liable for damages to the equipment, persons or animals caused by failure to observe the above instructions.

General precautions for a correct harness position

• Securing the cables:
- Secure the harness so that it does not interfere with moving parts.
- Route the harnesses so that they cannot be damaged or broken by machine movements or twisting.
• Fitting the cables to the connection points:
- Do not force the connectors by pushing too hard or bending them: the contacts may be damaged and device operation may be compromized.
Use ONLY the cables and accessories indicated in the catalog, having technical features suitable for the use to be made of
them.

Harness connection

WARNING: The A-net and ISOBUS models of the joystick are not interchangeable.
They use the same connector but are equipped with two different types of software.
Connect the joystick connector to the relevant harness; make sure it is correctly fitted and push it until locking it.
Fig. 6
The joystick has been designed to be connected to ARAG devices but can also be connected to equipment made by other manufacturers as long as
they are designed for devices of this typology. The joystick connections (Fig. 8) are indicated in the table.
Fig. 8
Fig. 7
POSITION COLOUR
1 black
2 red
3 white
4 green
5 yellow
CONNECTION
ECU GND
+12 VBat
(fixed supply)
ECU PWR
+12 V 15/54
(enables power)
CAN L
CAN H
11