Operation Start Procedure - Volpi KV100 Mode D'emploi

•
Connect the cable with pruner tightly:
•
Fasten your belt of the backpack
•
Check the closed position of blade
•
Grip the pruning shear handle part tightly
•
Connect the cable from the right side; please reverse the direction of the battery for left-hander

13 Operation start procedure

Please wear suitable cloth and glove when operate this tool. Always check tools before use,
make sure on/off switch and safe switch are all ok. The power should be put off when you
loosen the trigger. Stop using the tool in case of switch failure. Always check rated voltage
of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure blade stop fully before
touch it, otherwise blade will hurt your body.
•
Turn on the power switch. After warning tone, please pull the trigger two times without holding.
And the shear will be on working condition after one more warning tone. Don't overload cutting,
it will protect pruning shear and battery not be damaged. Don't cutting over 35 mm living plant or
25mm dry branch.
•
User just loose trigger when the blade has been jammed by branch, the blade will resume
maximum position.
Caution: Don't sway the pruner from the left to right in order not to damage the edge of blade
during the resume process of blade.
Check the working frequency of the blade in order to verify the good working condition.
When you stop working, please press the trigger and maintain 3 seconds unchanged then the blade will
keep closed state. Then turn off the power switch and pull out the cable from the battery.
30