Battery Charging Procedure; Working Environment; Assemble - Volpi KV100 Mode D'emploi

Always make sure the battery is dry and clean before charging.
•
Make sure the battery is fully charged before first time using.
•
The battery is not fully charged when you buy, you must charge 3-5 hours before using first time.
•
Re-charging battery when indicator shows one LED light.
•
Need to replace battery if battery running time is not enough. Users can only use the original
equipment manufactured by the customer center (OEM) battery pack.
•
Keep safety rules and environment protection information in mind all the time.

10.1 Battery charging procedure

•
Charge at temperature of ＋10°C~＋22°C indoor.
•
Make sure the switch at "OFF" position before charging.
•
Connect adaptor of charger with battery correctly.
•
Make sure specifications on battery and adapter matched before charging.
•
Red LED light on the charger indicates the battery is charging, green LED light indicates fully
charged, average charging time is about 4-5 hours.
•
Please make sure the battery charged at least once every 6 months when the battery is not using.

11 Working environment

•
Keep temperature of environment at 10°C ~ 22°C when charging battery, 0°C ~ +45°C when battery
is working.
•
Keep tool at temperature of 0°C ~ 60°C when working

12 Assemble

Please check pruner, cable and battery all clean and dry. Assemble as below steps:
•
Take out the backpack from the case.
•
Put battery into the backpack.
•
Double check nobody around of you and keep yourself away from the pruner and connect the
cable with battery tightly:
29