Control - Introduction; Display Unit - Nibe RMU S40 Manuel D'installation

WIRELESS CONNECTION
1. Go to the main product and select menu 5.4 – "Connect
wireless units" and follow the guide. Here, you give each
RMU S40 a unique name.
TIP
Go to menu 2 – "Connections" to find the start
guide again at a later date.
2. Select wireless connection in your RMU S40.
3. Wait for the message "Connection succeeded".
4. Make your settings for RMU S40 in the main product's
menu 1.3.3 – "Room units".
Caution
See the Installer Manual for the main product.
WIRED CONNECTION
In order to give RMU S40 a unique name in the main product,
it must first be allocated an address, a number (1 – 8):
1. Select an address for RMU S40 by allocating it a unique
number (1 – 8) in menu 2 - "Connections".
2. Go to the main product and select menu 7.2.1 –
"Add/remove accessories" and activate RMU S40 or
press "Search for accessories".
3. Select wired connection in your RMU S40.
4. Select an address (1 – 8) for your RMU S40.
In the event of a communication fault between RMU S40
and your main product, you are asked to check the se-
lected address and adjust if necessary.
5. Make your settings for RMU S40 in the main product's
menu 1.3.3 – "Room units".
Caution
See the Installer Manual for the main product.
NIBE RMU S40 | EN

Control - Introduction

DISPLAY UNIT

Space for memory card
Display
N N
K IT C H E K IT C H E
2 2 . 3 ° 2 2 . 3 ° 2 2 . 3 °
r r r
O u td o o O u td o o O u td o o
- 5 . 6 ° - 5 . 6 °
0 5 J a n
1 2 :4 5
Status lamp
On/Off button
THE STATUS LAMP
The status lamp indicates current operating status. It:
• is not lit during normal operation.
• lights red in the event of a deployed alarm.
If the status lamp is red, you receive information and sug-
gestions for suitable actions on the display.
THE ON/OFF BUTTON
The on/off button (SF1) has two functions:
• start
• switch off
To start: Move the switch up.
To turn off: Move the switch down.
THE DISPLAY
Instructions, settings and operational information are shown
on the display.
SPACE FOR MEMORY CARD
On the left side of the room unit, there is space for a memory
card (Micro-SD)
TIP
RMU S40 is updated automatically from the main
product when new software is available.
u a r y
23