Aa Battery Maintenance - NewAge Products 66992 Guide D'installation Et D'utilisation

AA Battery Maintenance

• You must read following instructions before using AA dry cell batteries for Grill. Failure
to read and follow the below instructions may result in fire, personal injury and damage
to property if used improperly.
• DO NOT insert an old/used AA dry cell battery into the battery pocket of the Pulse
Igniter.
• Always store AA battery in its original brand packaging, or place them in a plastic
container.
• Keep batteries in a cool location with low humidity and make sure they are aligned in
the same polarity direction.
• In case of rechargeable AA dry cell battery, NEVER make wrong polarity connection
while charging and discharging the battery.
• By any type of misuse, the harmful chemicals inside the battery may come out and
could damage the battery pocket of the Pulse Ignitor.
• DO NOT place or insert flammable chemical or material inside the Pulse Igniter battery
pocket for cleaning purpose. Any type of chemical or flammable material in the vicinity
of the Grill may cause dangerous fire at the location Grill is placed.
• DO NOT direct contact the chemical in case it is spilled out of the battery pocket. It
could be allergic to human body.
WARNING
Cleaning the battery pocket of the Pulse Igniter :
Cleaning the battery pocket is a must when the battery
doesn't work properly or battery chemicals are observed spill
out from the case. Always keep all the burner knobs and fuel
source valves to OFF position before starting cleaning process
of the battery pocket.
1. Read carefully the
Operating Practices"
2. Make sure all control knobs are set to OFF position.
3. Rotate the Pulse Igniter knob in anticlockwise direction
and take out the AA dry cell battery.
4. Using a clean brush or clean cloth, remove the debris,
decomposed black carbon on the spring and inner faces as
shown.
5. Insert a new AA battery with correct polar positioning
(Positive and Negative poles) of the battery as shown in
" Installing Main Grill
6. Enclose the AA battery pocket of the Pulse Ignitor using
the knob and tighten it by rotating in clockwise direction.
"Leak Testing Instructions"
sections with proper attention.
Parts".
and the "Safe
37