NewAge Products 66992 Guide D'installation Et D'utilisation page 19

Installing Grill on custom built cabinet
Propane gas Cylinder Connections
Make sure the Propane gas cylinder valve is fully closed. It is possible for the valve to be open
without releasing gas but, as soon as you start connecting the regulator, gas will leak from the
connection.
Insert the regulator inlet into the cylinder valve and turn the black coupler nut clockwise until the
coupler nut is hand tight. Do not over-tighten this connection. See Figure 1 & 2.
To disconnect the coupler nut, first make sure the main cylinder valve is turned off. Grasp the
coupler nut and turn counter clockwise. The inlet will then disengage.
Always leak-test the connection after refilling or exchanging Propane gas cylinders.
Dust Cap - Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install
the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types
of caps or plugs may result in leakage of propane.)
Propane cylinder must include a collar to protect the cylinder valve.
For an outdoor cooking gas appliance provided with a connection other than a No. 600. : "Turn off
LP supply at cylinder when appliance is not in use. "
For an outdoor cooking gas appliance provided with a No. 600 Connection : "The LP gas supply
cylinder must be disconnected when this appliance is not in use. "
Cylinder Valve
Coupling Nut
Propane Dust Cap (not included)
(used when in storage
or transportation.)
Propane Regulator
(included)
Note: The maximum length of the gas connection shall be 6 ft (1.82 m).
Pressure Relief Valve
Valve
Protection
Collar
Propane Tank
(not included)
Hand tighten to ensure proper seal for correct gas
Figure 1.
flow.
Figure 2.
19