Kohler K-15000 Serie Guide D'installation page 3

Escutcheon
Apply Plumbers
Putty.
Gasket
1. Faucet Body Installation
Apply a bead of plumbers putty to the underside of the faucet
body according to the putty manufacturer's instructions.
NOTE: Do not use plumbers putty to install a single-control faucet
body to a marble or plastic bidet. Instead, remove the backing from
the two gaskets. Firmly press one gasket onto each outside
mounting hole.
Place a spacer over the spout mounting hole, so the gasket
surface is down. Position the center over the three mounting
holes.
Slide the rubber washer over the supply tubing and into the
groove on the faucet body.
From the top of the bidet, insert the faucet body into the
mounting hole.
Insert the lift rod into the faucet body.
From the underside of the bidet, slide the bracket and nut onto
the mounting stud.
Rotate the spout until it is aligned to face straight forward from
the bidet. Securely tighten the nut.
Remove any excess putty or sealant.
Kohler Co.
Lift Rod
Faucet Body
Mounting
Stud
Bracket
Spacer
Nut
3
Rubber
Washer
Supply
Tubing
116371-2-AB