Publicité
Les langues disponibles
Les langues disponibles
starting delay circuit. This enables
the model to produce standing
sounds and to move the pantographs
up and down while it is stopped.
Lighting
This model has automatic directional
lanterns on the front and the rear of
the loco: three white lanterns on the
front and two red lanterns on the
rear. The control panels inside the
cabs are equipped with white lights
for background lighting along with
small LEDs. Several LEDs are illumi-
nated in the front cab. One is illumi-
nated in the rear.
This model has "flat" multi-purpose
sockets, with removable covers, on
the front and rear of the loco. These
sockets can be used to provide track
power to cars with lighting or sound
electronics.
To remove the cover of the socket,
pull it straight out. If the cover is
tight, gently use a small straight
screwdriver to pry it out. (Do not pull
out the rectangular outer housing.)
Catenary Power Operation
This locomotive can be operated with
a powered catenary system (see
Operating Modes). The bottom of this
model is marked with a red dot. Place
the model on the track with the red dot
pointing to the rail that is not con-
nected to the catenary power supply.
Hint: To operate multiple trains on
the same track, we recommend the
LGB Multi-Train System (see Multi-
Train System). With the Multi-Train
System, you can use an unpowered
catenary system for prototypical
appearance.
CAUTION! This model may be pow-
ered with a catenary on analog lay-
outs only. For operation with the dig-
ital Multi-Train System, the model
must use track power. Otherwise,
dangerously high voltages may
result.
Attention! After extended operation,
this model may leave carbon dust or
other debris around the track. This
dust and debris can stain carpet and
other materials. Consider this when
setting up your layout. LGB are not
liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level
- Beginner
Level
- Intermediate
Level
- Advanced
Attention! Improper service will void
your warranty. For quality service,
contact your authorized retailer or an
LGB factory service station (see
Authorized Service).
Lubrication
The axle bearings should be lubricat-
ed occasionally with a small amount
of LGB Maintenance Oil (50019).
Cleaning
This model can be cleaned externally
using a mild detergent and gentle
stream of water. Do not immerse this
model.
Attention! This model is equipped
with sound electronics. Do not
expose the speaker directly to water.
Replacing the light bulbs
Lanterns: Carefully pry the lens away
from the lantern. Using tweezers,
remove and replace the bulb.
Reassemble.
Cab light: Using tweezers, remove
and replace the bulb.
19
Publicité
