Witter DT124B Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar with European facing to 94/20/EC A50-1
B 1 10mm Coupling Packer
E 1 Left hand angle cleat
F 1 Right hand angle cleat
G 10 M12 x 40mm x 1.25mm Bolts, Lock Washers and Flat Washers
H 4 M12 x 35mm x 1.75mm Bolts and Nyloc Nuts and Flat Washers
I 1 ZEP35 Electrical plate (not shown)
CB 2 M16 x 50mm Coupling Bolts, Nuts, Lock Washers
FITTING
1. Remove bolts securing towing eye to vehicle chassis- discard towing eye and bolts.
2. Loosely attach Cross Bar (A) and Angle Cleats (E) and (F) to chassis using Bolts (G) and (H).
3. Fully tighten bolts. Coupling packer (B) should be used when towball is fitted to lower set of holes.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY witter-towbars.co.uk
µW0001DT124B-FIT$021210160000`Ä
W0001DT124B-FIT$021210160000
TOWBAR
For NISSAN NAVARA
WITH STEP BUMPER
JULY 2005 -
DT124B
Issue 2