Clean / Pulse: If you wish to blend food with short pulses, switch this control knob
alternately until you obtain the desired mixture. This function can be used for cleaning
the jar. To do this, pour water and a little cleaning product into the jar.
While the motor is running, you can add ingredient. To do that, remove the
measuring cap (A) by turning it counter clockwise:
To remove the lid, turn it counter clockwise.
1.
Add the ingredients into the jar through the opening in the lid.
2.
When you have finished, switch off the blender by unplugging it.
To put out the contents of the jar, remove the lid from the jar and remove the jar
from the motor base before putting out the contents of the jar.
The temperature for the food to be mixed shall not exceed 60°C.
The volume of food to be processed shall not exceed the maximum mark level on
the blender jar.
b) Tips for use
Switch off the appliance and turn the control knob to pulse position a few times to
lest the blender run briefly.
Use a spatula to stir the ingredients, either while the blender is running or while
the blender is switched off.
Switch off the appliance; remove part of the ingredients from the jar process a
smaller amount.
Add more liquid.
4) CLEANING AND MAINTENANCE
a) Cleaning the liquidizer
The appliance is easier to clean if you do so immediately after use.
Unplug the appliance, remove the jar, remove the blending blade assembly from the
1.
jar by carrying out the assembly procedure in reverse order (see the section "2/ C.
Assembling the blender").
Clean these parts with the cleaning brush in warm water with some washing-up liquid
2.
and rinse them under the tap.
Clean the motor base with a dry cloth. Do not submerge the motor base in water or
3.
in any other liquid, and do not place it under the tap.
19