Witter IV02A Instructions

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 1 Coupling Packer
C 1 Left hand sidearm
D 1 Right hand sidearm
E 1 Left hand Chassis Stiffener
F 1 Right hand Chassis Stiffener
G 4 M12 x 40 x 1.75 Bolts and Nyloc Nuts.
H 6 M14 x 40 x 2.00 Bolts and Nyloc Nuts
J 2 M14 x 40 x 2.00 Bolts and Nyloc Nuts
CB 2 M16 x 50mm Coupling Bolts, Nuts, Lock Washers
Z 1 ZEP35 Electrical Plate (not shown)
FITTING
Remove bolts securing rear light panel to vehicle chassis (2 bolts each side). Insert Chassis Stiffeners (E) and
1.
(F) inside chassis frame. Loosely secure Sidearms (C) and (D) to lower face of chassis and Chassis Stiffeners
(E) and (F) using bolts (G) and (J) as shown below (drill out rearmost hole to 14mm for Bolts J).
Loosely attach Cross Bar (A) to Sidearms (C) and (D) using Bolts (H). Note: it is necessary to determine the
2.
optimum position for mainframe (A) this may be at either set of holes (H) giving an extension of 70mm.
3. Secure rear light panel to vehicle chassis using original bolts (these bolts must be fitted – otherwise chassis
failure may occur) and Fully Tighten all bolts.
NOTE: This towbar is EC type approved to be used with a Class A50-X towball with a 'D' Value greater than or equal to that of
the towbar. Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
µW0001IV02A-FIT$011210160000!Ä
W0001IV02A-FIT$011210160000
For IVECO DAILY TIPPERS
www.witter-towbars.co.uk
IV02A
TOWBAR
Issue 1