After Usage/Storage
Clean the exterior of the machine thoroughly using a soft brush and cloth. Do not use water, solvents or polishes.
Remove all grass and debris, especially from the ventilation slots.
Turn the machine on its side and clean the blade area. If grass cuttings are compacted in the blade area, remove
with a wooden or plastic implement.
● Always wear gardening gloves when handling or working near the sharp blades.
Store the machine in a dry place. Do not place other objects on top of the machine. To save space, fold up the
handle fully.
● Ensure the cables are not trapped when folding/unfolding top/bottom handles. Do not drop the
handles.
The machine can be stored with the grass box disassembled.
Battery storage
_ Store and charge your batteries in cool area. Temperatures below 10 ° C (50 ° F) or above
38 ° C (100 ° F) will shorten battery life.
_ Never store batteries in discharged condition. Recharge them immediately after they are discharged.
_ Batteries gradually lose their charge, the higher the temperature the quicker, so If you store your tool for longer
periods of time without using it, recharge the batteries every month or two. This will prolong battery life.
Transport
The battery is tested according to UN document ST/SG/AC.10/11/Rev.3 Part III, subsection 38.3. It has effective
protection against internal overpressure and short circuiting as well as devices for the prevention of violent rupture
and dangerous reverse current flow.
The lithium-equivalent content in the battery is below applicable limit values. Therefore, the battery is not subject
to national or international regulations pertaining to dangerous mediums, neither as an individual component nor
when inserted into a machine. However, the regulations governing dangerous goods may be relevant when
transporting several batteries. In this case, it can be necessary to comply with special conditions (e.g., concerning
the packaging).
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-sales service department.
_ If replacing the power cord is necessary, it should be done by the manufacturer or his agent to avoid a
hazard.
AFTER-SALES SERVICE AND APPLICATION SERVICE
Our after-sales service responds to your questions concerning maintenance and repair of your product as well as
spare parts. Exploded views and information on spare parts can also be found
ELEM GARDEN TECHNIC application service team will gladly answer questions concerning our products and
their accessories : sav@eco-repa.com
Guarantee
Refer to the enclosed guarantee conditions for the terms and conditions of guarantee
Environment
Should your machine need replacement after extended use, do not put it in the domestic
waste but dispose of it in an environmentally safe way.
Unwanted batteries should be disposed of in an environmentally friendly way and in
Discharge the battery by letting the machine run at no load speed until the motor
Hand in the battery as chemical waste with the recycling station in your municipality.
Batteries
conformance with the local regulations.
stops.
Remove the battery from the machine.
Vervaardigd in China
under:www.eco-repa.com
2015
62