Technician Menu - Bodet Opalys Ellipse Instructions De Mise En Service Et D'utilisation

VII - TECHNICIAN MENU
Access to the technician menu is via the two push buttons [SELECT] and [+] located on the back
of the clock. The [SELECT] button is above the [+] button.
Proceed in two stages.
1. Press the [SELECT] button, and while holding it down, press [+] for more than 3 seconds to go
initially to Configuration menu.
2. Press the [SELECT] button, and while holding it down, press [+] for more
than 7 seconds to go to Technician menu. The programme version for
the clock is displayed.
3. Press the [SELECT] button to display the menu for the type of synchro.
The [+] button enables you to choose between Ind and Sync (if the
synchro card is connected) or Ind, DHF and DHFi.
Ind : autonomous mode (deactivates radio card or pulse/coded time
reception card).
Sync : activates the radio synchronisation card or coded time pulse
reception.
DHF: activation of the DHF synchronisation card. After 24 hours
without signal, the clock stops.
DHFi : activation of the DHF synchronisation card. After 24 hours
without signal, the clock keeps on working on its own time basis.
The default configuration of the DHF receiver clock is DHFi.
4. Press [SELECT], according to the clock's option and the previous selection :
Ind : the programme of the clock go directly to the step "Test display".
Sync (radio) : The Radio Reception menu is displayed. The radio
pictogram flashes to indicate that the search is under way. The
display shows the construction of the time message as and when the
data arrives.
Sync (implulse) : Select with the [+] button the impulse type between.
42
Min : Minutes // impulses network.
1:2M : ½ Minutes // impulses network.
AFn : Afnor NFS87500A coded time network. After
24 hours without signal, the clock stops.
AFni : Afnor NFS87500A coded time network. After
24 hours without signal, the clock keeps on working
on its own time basis.
IriG : Irig B coded time network.
The default configuration of the AFNOR receiver
clock is AFNORi.